kernel compile

vreau sa recompilez kernelul :os : FreeBSD 4.10#hardware :1) CPU : PENTIU 100 mhz2) RAM : 16 mb3) HDD : western digital 10 gb 4) 2 NIC RLT PCI/ISAajutati sa-l compilez, poate ceva sfaturi, poate am scos pre multe !machinei386cpuI386_CPU#cpuI486_CPU#cpuI586_CPU#cpuI686_CPUident SRV_KERNELmaxusers0#makeoptionsDEBUG=-g#Build kernel with gdb(1) debug symbolsoptions MATH_EMULATE#Support for x87 emulationoptions INET#InterNETworkingoptions INET6#IPv6 communications protocolsoptions FFS#Berkeley Fast Filesystemoptions FFS_ROOT#FFS usable as root device [keep this!]options SOFTUPDATES#Enable FFS soft updates supportoptions UFS_DIRHASH#Improve performance on big directoriesoptions MFS#Memory Filesystemoptions MD_ROOT#MD is a potential root deviceoptions NFS#Network Filesystemoptions NFS_ROOT#NFS usable as root device, NFS requiredoptions MSDOSFS#MSDOS Filesystemoptions CD9660#ISO 9660 Filesystemoptions CD9660_ROOT#CD-ROM usable as root, CD9660 requiredoptions PROCFS#Process filesystemoptions COMPAT_43#Compatible with BSD 4.3 [KEEP THIS!]options SCSI_DELAY=15000#Delay (in ms) before probing SCSIoptions UCONSOLE#Allow users to grab the consoleoptions USERCONFIG#boot -c editoroptions VISUAL_USERCONFIG#visual boot -c editoroptions KTRACE#ktrace(1) supportoptions SYSVSHM#SYSV-style shared memoryoptions SYSVMSG#SYSV-style message queuesoptions SYSVSEM#SYSV-style semaphoresoptions P1003_1B#Posix P1003_1B real-time extensionsoptions _KPOSIX_PRIORITY_SCHEDULINGoptions ICMP_BANDLIM#Rate limit bad repliesoptions KBD_INSTALL_CDEV# install a CDEV entry in /devoptions AHC_REG_PRETTY_PRINT# Print register bitfields in debug# output. Adds ~128k to driver.options AHD_REG_PRETTY_PRINT# Print register bitfields in debug # output. Adds ~215k to driver.# To make an SMP kernel, the next two are needed#options SMP# Symmetric MultiProcessor Kernel#options APIC_IO# Symmetric (APIC) I/Odeviceisadeviceeisadevicepci# Floppy drives#devicefdc0at isa? port IO_FD1 irq 6 drq 2devicefd0at fdc0 drive 0devicefd1at fdc0 drive 1## If you have a Toshiba Libretto with its Y-E Data PCMCIA floppy,# don't use the above line for fdc0 but the following one:#devicefdc0# ATA and ATAPI devicesdeviceata0at isa? port IO_WD1 irq 14deviceata1at isa? port IO_WD2 irq 15deviceatadeviceatadisk# ATA disk drivesdeviceatapicd# ATAPI CDROM drivesdeviceatapifd# ATAPI floppy drives#deviceatapist# ATAPI tape drivesoptions ATA_STATIC_ID#Static device numbering# SCSI Controllers#deviceahb# EISA AHA1742 family#deviceahc# AHA2940 and onboard AIC7xxx devices#deviceahd# AHA39320/29320 and onboard AIC79xx devices#deviceamd# AMD 53C974 (Tekram DC-390(T))#deviceisp# Qlogic family#devicempt# LSI-Logic MPT/Fusion#devicencr# NCR/Symbios Logic#devicesym# NCR/Symbios Logic (newer chipsets)#options SYM_SETUP_LP_PROBE_MAP=0x40# Allow ncr to attach legacy NCR devices when # both sym and ncr are configured#deviceadv0at isa?#deviceadw#devicebt0at isa?#deviceaha0at isa?#deviceaic0at isa?#devicencv# NCR 53C500#devicensp# Workbit Ninja SCSI-3#devicestg# TMC 18C30/18C50# SCSI peripherals#devicescbus# SCSI bus (required)#deviceda# Direct Access (disks)#devicesa# Sequential Access (tape etc)#devicecd# CD#devicepass# Passthrough device (direct SCSI access)# RAID controllers interfaced to the SCSI subsystem#deviceasr# DPT SmartRAID V, VI and Adaptec SCSI RAID#devicedpt# DPT Smartcache - See LINT for options!#deviceiir# Intel Integrated RAID#devicemly# Mylex AcceleRAID/eXtremeRAID#deviceciss# Compaq SmartRAID 5* series#devicetwa# 3ware 9000 series PATA/SATA RAID# RAID controllers#deviceaac# Adaptec FSA RAID, Dell PERC2/PERC3#deviceaacp# SCSI passthrough for aac (requires CAM)#deviceida# Compaq Smart RAID#deviceamr# AMI MegaRAID#devicemlx# Mylex DAC960 family#devicepst# Promise Supertrak SX6000#devicetwe# 3ware Escalade# atkbdc0 controls both the keyboard and the PS/2 mousedeviceatkbdc0at isa? port IO_KBDdeviceatkbd0at atkbdc? irq 1 flags 0x1devicepsm0at atkbdc? irq 12devicevga0at isa?# splash screen/screen saverpseudo-devicesplash# syscons is the default console driver, resembling an SCO consoledevicesc0at isa? flags 0x100# Enable this and PCVT_FREEBSD for pcvt vt220 compatible console driver#devicevt0at isa?#options XSERVER# support for X server on a vt console#options FAT_CURSOR# start with block cursor# If you have a ThinkPAD, uncomment this along with the rest of the PCVT lines#options PCVT_SCANSET=2# IBM keyboards are non-stddeviceagp# support several AGP chipsets# Floating point support - do not disable.devicenpx0at nexus? port IO_NPX irq 13# Power management support (see LINT for more options)deviceapm0at nexus? disable flags 0x20 # Advanced Power Management# PCCARD (PCMCIA) supportdevicecarddevicepcic0at isa? irq 0 port 0x3e0 iomem 0xd0000devicepcic1at isa? irq 0 port 0x3e2 iomem 0xd4000 disable# Serial (COM) portsdevicesio0at isa? port IO_COM1 flags 0x10 irq 4devicesio1at isa? port IO_COM2 irq 3devicesio2at isa? disable port IO_COM3 irq 5devicesio3at isa? disable port IO_COM4 irq 9# Parallel portdeviceppc0at isa? irq 7deviceppbus# Parallel port bus (required)devicelpt# Printerdeviceplip# TCP/IP over paralleldeviceppi# Parallel port interface device#devicevpo# Requires scbus and da# PCI Ethernet NICs.#devicede# DEC/Intel DC21x4x (``Tulip'')#deviceem# Intel PRO/1000 adapter Gigabit Ethernet Card (``Wiseman'')#devicetxp# 3Com 3cR990 (``Typhoon'')#devicevx# 3Com 3c590, 3c595 (``Vortex'')# PCI Ethernet NICs that use the common MII bus controller code.# NOTE: Be sure to keep the 'device miibus' line in order to use these NICs!#devicemiibus# MII bus support#devicedc# DEC/Intel 21143 and various workalikes#devicefxp# Intel EtherExpress PRO/100B (82557, 82558)#devicepcn# AMD Am79C97x PCI 10/100 NICsdevicerl# RealTek 8129/8139#devicesf# Adaptec AIC-6915 (``Starfire'')#devicesis# Silicon Integrated Systems SiS 900/SiS 7016#deviceste# Sundance ST201 (D-Link DFE-550TX)#devicetl# Texas Instruments ThunderLAN#devicetx# SMC EtherPower II (83c170 ``EPIC'')#devicevr# VIA Rhine, Rhine II#devicewb# Winbond W89C840F#devicexl# 3Com 3c90x (``Boomerang'', ``Cyclone'')#devicebge# Broadcom BCM570x (``Tigon III'')# ISA Ethernet NICs.# 'device ed' requires 'device miibus'deviceed0at isa? disable port 0x280 irq 10 iomem 0xd8000deviceexdeviceepdevicefe0at isa? disable port 0x300# Xircom Ethernet#devicexe# PRISM I IEEE 802.11b wireless NIC.#deviceawi# WaveLAN/IEEE 802.11 wireless NICs. Note: the WaveLAN/IEEE really# exists only as a PCMCIA device, so there is no ISA attachment needed# and resources will always be dynamically assigned by the pccard code.#devicewi# Aironet 4500/4800 802.11 wireless NICs. Note: the declaration below will# work for PCMCIA and PCI cards, as well as ISA cards set to ISA PnP# mode (the factory default). If you set the switches on your ISA# card for a manually chosen I/O address and IRQ, you must specify# those parameters here.devicean# The probe order of these is presently determined by i386/isa/isa_compat.c.deviceie0at isa? disable port 0x300 irq 10 iomem 0xd0000#devicele0at isa? disable port 0x300 irq 5 iomem 0xd0000devicelnc0at isa? disable port 0x280 irq 10 drq 0devicecs0at isa? disable port 0x300devicesn0at isa? disable port 0x300 irq 10# Pseudo devices - the number indicates how many units to allocate.pseudo-deviceloop# Network loopbackpseudo-deviceether# Ethernet supportpseudo-devicesl1# Kernel SLIPpseudo-deviceppp1# Kernel PPPpseudo-devicetun# Packet tunnel.pseudo-devicepty# Pseudo-ttys (telnet etc)pseudo-devicemd# Memory "disks"pseudo-devicegif# IPv6 and IPv4 tunnelingpseudo-devicefaith1# IPv6-to-IPv4 relaying (translation)# The `bpf' pseudo-device enables the Berkeley Packet Filter.# Be aware of the administrative consequences of enabling this!pseudo-devicebpf#Berkeley packet filter# USB support#deviceuhci# UHCI PCI->USB interface#deviceohci# OHCI PCI->USB interface#deviceusb# USB Bus (required)#deviceugen# Generic#deviceuhid# "Human Interface Devices"#deviceukbd# Keyboard#deviceulpt# Printer#deviceumass# Disks/Mass storage - Requires scbus and da#deviceums# Mouse#deviceuscanner# Scanners#deviceurio# Diamond Rio MP3 Player# USB Ethernet, requires mii#deviceaue# ADMtek USB ethernet#devicecue# CATC USB ethernet#devicekue# Kawasaki LSI USB ethernet# FireWire support#devicefirewire# FireWire bus code#devicesbp# SCSI over FireWire (Requires scbus and da)#devicefwe# Ethernet over FireWire (non-standard!)